ActronAir MultiElite 2 MRC-075CS-3, Руководство пользователя

Страница: 15 / 20

Owner's Manual
Multi Split System
Owner's Manual - MultiElite 2 Split System
Doc. No. 9590-4012 Ver. 2 220616
15
10. Error Codes (Indoor Unit)
When troubles occur, please check the following points before contacting a qualified service technician.
When the indoor unit encounters a recognized error on different models ,
1. the running LED with flash in a corresponding series, the timer LED may turn on or begin flashing;
2. an error code will be displayed;
3. both 1 and 2.
These error codes are described in the following tables:
Running
Lamp
Timer
Lamp
Display Information Solution
-- -- Defrost
Normal
Display, not
error code
-- -- Filter cleaning reminder (power on display for 15 seconds)
-- -- Active clean
-- -- Filter replacement (power on display for 15 seconds)
-- -- Heating in room temperature under 8 °C
-- -- Forced cooling
-- -- AP mode of WIFI connection
-- -- Remote switched off
1 time OFF Indoor unit EEPROM parameter error TS23
2 times OFF Indoor/Outdoor units communication error TS24
3 times OFF Zero-crossing signal detection error TS41
4 times OFF The indoor fan speed is operating outside the normal range TS27
5 times OFF Outdoor unit EEPROM parameter error TS23
5 times OFF
Condenser coil temperature sensor T3 is in open circuit or has short
circuited
TS29
5 times OFF
Outdoor room temperature sensor T4 is in open circuit or has short
circuited
TS29
5 times OFF
Compressor discharge temperature sensor TP is in open circuit or
has short circuited
TS29
5 times OFF
Evaporator coil outlet temperature sensor T2B is in open circuit or
has short circuited
TS29
6 times OFF
Indoor room temperature sensor T1 is in open circuit or has short
circuited
TS29
6 times OFF
Evaporator coil middle temperature sensor T2 is in open circuit or
has short circuited
TS29
12 times OFF The outdoor fan speed is operating outside the normal range TS27
9 times OFF Indoor PCB/Display board communication error TS50
7 times FLASH IPM malfunction or IGBT over-strong current protection TS32
2 times FLASH Over voltage or over low voltage protection TS34
3 times FLASH
Top temperature protection of compressor or High temperature
protection of IPM module or High pressure protection
TS42
5 times FLASH Inverter compressor drive error TS32
1 time FLASH Current overload protection TS30
6 times FLASH
Communication error between outdoor main chip and compressor
driven chip
TS36
7 times FLASH High or low pressure protection TS43/TS45
1 time ON Indoor units mode conflict (match with multi outdoor unit) --