ActronAir LM24-2G, Руководство по эксплуатации

Страница: 4 / 28

Operation Manual
LM7/24-2 Wall Controller
Operation Manual LM7-2 / LM24-2 Wall Controller
Document No. 0525-079 Ver. 1 190821
Page 4
02. Waste Electrical and Electronic Equipment Disposal Guidelines
1. Do not dispose off the waste electrical and electronic equipment with local council waste. These must be
disposed off through the council designated hazardous waste collection centre.
2. The equipment may contain hazardous substances, improper or incorrect disposal may have a negative effect
on human health and on the environment.
03. Maintenance
1. Keep the control interface clean with the use of a soft dry cloth only. If a cleaning solution is needed, use a very mild
soap solution to dampen the cloth. Do not spray or squirt any liquid onto your control interface.
2. Do not use solvent base cleaner, which can cause damage to the control interface.
3. When cleaning, be careful not to accidentally press any Buttons, TURN-OFF the unit to ensure that no adverse unit
operation is initiated by accidentally pressing any Buttons.
4. Be careful not to press hard into the display screen, as it may get damaged.
5. Ensure that the temperature sensor is always clean and free of dust or dirt build-up to maintain sensor accuracy.
6. Do not pull apart or attempt to service the control interface, should you need service to the device, contact
ActronAir Service Department on 1800 119 229.
04. Safety Precautions
1. Read all instructions in this manual before operating the air conditioning unit. Failure to do so may result in damage
to the unit and void your warranty.
2. Turn-Off the power supply to the unit and follow sound Lock Out and Tag Out procedures to ensure that power
supply is not re-energised accidentally.
3. Beware of EC Motors with high power capacitors and which can have dangerous voltages at terminals for up to 5
min. after main power has been isolated. Wait at least 5 minutes after power isolation and test for high voltage before
performing service work.
4. This control interface has power supplied from the indoor board controller via screwed terminals and 4 Core Twisted
Pair Data cable. Ensure that this unit is not installed on voltages other than specified.
5. Installation and servicing must be carried out by a qualified technician.
6. Ensure that the unit installation complies with relevant council regulations and building code standards. All electrical
wiring must be in accordance with current electrical authority regulations and all wiring should follow the electrical
diagrams provided.
7. WH&S rules and regulations must be observed and will take precedence during installation process.
8. Only use this control interface with an ActronAir air conditioner as described in this operating manual.