573102 | REV. A | 07.2015
Bosch Automotive Service Solutions Inc.
CP9680
AutoScanner® Plus
| User guide |
33
|
en
Record Data
Playback data?
No
Yes
5.8
View Freeze Data
When an emission-related fault occurs, certain vehicle
conditions are recorded by the on-board computer. This
information is referred to as freeze frame data.
View
Freeze Data
is a snapshot of the operating conditions at
the time of an emission-related fault.
View Freeze Data
can be overwritten by faults with a higher priority. If
codes were erased,
View Freeze Data
may not be stored
in vehicle memory depending on vehicle.
From
Diagnostic Codes Menu
:
1. Select
View Freeze Data
.
•
Use the
UP
and
DOWN
keys until
View
Freeze Data
is highlighted.
•
Press
.
Diagnostic Codes
Read Codes
Erase Codes
View Freeze Data
Component Locator
Acronyms
Review Data
Print Data
Code Lookup
System Setup
2. Select frame, if more than one frame is present.
•
Use the
UP
and
DOWN
keys until the
desired frame is highlighted.
•
Press
.
Select Data to View
P0102 (MOD $10)
Long PID Names
English/Metric
3. View PIDs on scan tool.
•
Use the
UP
and
DOWN
keys.
•
See Appendix A for PID definitions.
TROUB CODE
FUEL SYS 1
FUEL SYS 2
CALC LOAD(%)
COOLANT (°F)
ST FTRM1(%)
LT FTRM1(%)
MAP(”HG)
ENG SPEED(RPM)
VEH SPEED(MPH)
P2122
N/A
N/A
0.0
-40
0.0
0.0
28.1
0
0
Definition that caused Freeze Fra
•
If Long PID Names is turned on, the expanded
text for the PID will scroll on the bottom line of
the display. See “Long PID Names” on page
13.
•
icon indicates that the
key is active.
Press the
key to display repair information.
Refer to “
CodeConnect®
” in section 3.
•
indicates that the
key is active. Press
the
key to display the DTC definition of the
DTC that created the Freeze Frame.
4. Select another frame to view (if available).
•
Press
.
5. Return to
Diagnostic Codes Menu
.
•
Press
.
5.9
Drive Cycle Monitor
The
Drive Cycle Monitor
function is very similar to
I/M
Monitors
though the
Drive Cycle Monitor
is used to
view real-time operations of the emissions system on
OBDII vehicles.
Drive Cycle Monitor
continuously
updates as the vehicle reports operations of the emis-
sion system.
CAUTION
Two people must be in vehicle when driving.
One to drive and the other to operate the
scan tool.
•
Refer to the vehicle service manual for the drive
cycle operation.
Drive Cycle Monitor
can be used if you want to drive the
vehicle until all of the monitors are OK.
During normal driving conditions, the vehicle computer
scans the emission system. After a specific amount of
drive time (each monitor has specific driving conditions
and time requirements), the computer monitors will
decide if the vehicle emissions system is working cor-
rectly or not as well as detecting out a range of values.
When the monitor status is:
•
“ok” - vehicle has been driven enough for function.
•
“inc” (incomplete) - vehicle was not driven enough
to complete all of the monitors.
•
“n/a” (not applicable) - vehicle does not support
that monitor.
Reset monitors by:
•
Erasing codes.
