7
Stud
5. Remove backing from the mounting
plate adhesive gasket.
6. Insert (4) 2” Threaded bolts into screw
holes at corners of mounting plate.
Attach (4) toggle bolt anchors to ends of
threaded bolts.
7. Insert (4) toggle bolts into 3/8” holes
in duct. Be sure toggle anchors open
after inserting.
8. Center large opening in the mounting plate
over 3.5” opening in duct and press plate
to duct. The adhesive gasket will hold the
mounting plate into place. Tighten toggle
bolts
- DO NOT OVERTIGHTEN.
9. Insert unit into opening. Be sure the air
will pass through the ActivePure
®
Cell
honeycomb matrix.
10. Secure the unit to the mounting plate
with four (4) thumb nuts.
FIBERGLASS DUCTWORK INSTALLATION
(CONTINUED)
NOTE:
Unit requires continuous power. Do not install where power to the unit will be cycled on and off.
