Active 5000 B, Инструкция по безопасности и эксплуатации

Страница: 17 / 64

ENGLISH
17
7) CUTTING HEIGHT ADJUSTMENT
The cutting height adjustment on steel models, is carried out by acting on the lever front and rear,
as shown in the first figure. In this case it is raised or lowered independently of the front and rear
axle. On models with centralized lifting , you need to grasp the lever, lift the sliding sleeve and take
it to one of seven positions, as shown in the second figure.
For 5800/5850 models it‘s as for steel models, but acting on each wheel.
8) MULCHING
1) In order to cut the grass in the Mulching mode, check that the grass height is not more than 20 cm,
otherwise it is necessary to cut by mounting the collection bag.
2) If it is moving in the mulching mode you must make sure that the grass is dry and sharp blade to
prevent the cut grass from collecting under the spiral of the shell.
3) Position the mulching closure in the grass expulsion compartment as shown in figure. For
aluminum models also fit the mulching blade.
4) Place the height of cut not less than 50 mm , start the engine and proceed with a normal grass
cutting.
5) After working in the Mulching mode it is highly recommended to perform a thorough cleaning to
remove grass clippings. For this operation, use the quick water connection, placed on the body. Turn
on the water tap and start the engine. The blade rotation and the water spray clean the inside of the
mower deck.
You can proceed with the same cleaning operation even after cutting with collection. In this case it is
advisable to remove the basket.