QUICK START GUIDE
HARRIER HDMI CAMERA INTERFACE BOARD
Version 1.5.1.s May 2021
Page 3 of 7
Sony Camera Control Application
To evaluate the serial communications capability you will need an application that can provide serial
communication via a COM port, for example the
Note: in its default build configuration, the Harrier HDMI Camera Interface Board only supports TTL
communications.
Harrier Evaluation Board Overview
Figure 7. Harrier Evaluation Board diagram
The Harrier Evaluation Board connects to the camera interface board using the supplied cable kit.
•
JTAG (J104)
- white 8-way cable (connects to J4; not required for normal use).
•
I/O (J102)
- 4-way cable (connects to J2).
•
Power/control RS-232 (J103) - 10-way cable (connects to J3).
The board is powered by the 12V power supply via a barrel connector (J306). This supply is also
used as a power supply for the camera and is connected to the camera via the Power Switch
(SW302). When the Power Switch (and camera power supply) is switched ON the PWR ON LED will
illuminate.
For more information please see the
Harrier Evaluation Board datasheet
on the
(see Harrier HDMI Camera Interface Board - Downloads section).
