Activa 12241 Dakota, Инструкция по сборке и эксплуатации

Страница: 20 / 23

Art. Nr.: 12241 Dakota
Seite 20 von 23
D
15. Malfunctions
If a malfunction should occur despite the use of quality materials as well as individual parts
tested by the German Technical and Scientific Association for Gas and Water (Deutscher
Verein des Gas- und Wasserfaches e.V.), please observe the following instructions:
Do not carry out any work on the gas-technical parts yourself, but leave
this to a specialist. In most cases, you can fix minor faults with the help of
the following table. In case of gas leakage, do not use the device and check
and repair it before using it again.
Malfunction Examine Repair
Gas smell emerges Check the sealing ring on the bottle
Search all gas-carrying parts with leak de-
tection spray or soapy water.
If defective, replace.
Tighten loose connections.
Device does not ignite
immediately Make sure that the gas valves are open.
Check that there are no sparks when the
appliance is lit.
Make sure that the burners are clean.
Check that the gas bottle is still full.
Open valve
Clean
Have gas cylinder refilled.
Burner does not ignite Is there still gas in the bottle?
Is the cylinder valve open?
Regulator defective?
Is the igniter connected correctly?
Injection nozzle or valve tubes clogged?
Is there a spark from the igniter?
Let the bottle fill up.
Turn on the valve.
Clean burner tubes
Install the igniter correctly accord-
ing to the instructions.
Check cable for defects.
Noises at the pressure
regulator Check whether the air vents on the pres-
sure regulator are blocked or clogged. Clean the opening and wait 5
minutes before restarting the
unit.
Flame flashback.
In rare cases, flames can
flash back into the burner
tube.
This results in a bubbling sound, or a small
explosion. Immediately close the gas supply
on the gas bottle. Wait one minute
and restart the grill. If the phe-
nomenon occurs again, the burn-
ers must be cleaned.
Flame ring unequal Burner/burner tube defective or clogged? Replace or clean burner
Flaring up of flames or
sparks Fat drain system clogged?
excessive fat in the meat
too high grill temperature
Clean the grill
cut fat from meat beforehand
Reduce temperature.
Insufficient heat output Injector or Venturi tubes clogged. Carefully clean both.