background image

 

The Primary, the Secondary, and IR910D should be placed very close to each other and all facing 

the same direction. Place a white paper in front of all three about 10 cm away. This way all three 

can see each other by reflection. Make sure IR910D can hear both both device's talks. 

 

The recorded data is written into a binary file LOG_RAW.BIN. 

 

If you want to keep it, you need to rename it (or copy it) to a different file name. Otherwise, it 

will be replaced when you run this program again. 

 

This file can be analyzed and translated into text files. 

 

Note: Each byte of IrDA signal resulted in three bytes in the LOG_RAW.BIN file. The first byte 

is the IrDA signal itself (as received by IR910D). The next two bytes is the 16-bit integer 

representing the time interval between this IrDA byte and the previous one. The unit of time is 

43.58 usec. 

 

(II) Translate To Text Files 

 

Run "XLATE.EXE" to translate LOG_RAW.BIN into LOG_PHY.TXT, LOG_PHY.TXT and 

LOG_LMP.TXT files. 

 

(III) Viewing The Text Files 

 

You may use any editor or word processor to view the ASCII text files generated. 

 

These text files are almost self- explanatory.  

 

But be aware of the following: 

 

a) LOG_PHY.TXT also include timing information. However, if the warning message 

"Wrong_timing_info!!!" shows up anywhere, the timing information of the entire file is invalid 

and should all be ignored. This is usually caused by running DOS under Windows. 

 

b) In LOG_PHY.TXT, the "#_usec" shows the time interval between the EOF of last frame 

and first byte of this frame. 

Содержание IR8200L

Страница 1: ...SW records IrDA protocol conversation from 9 6K to 115 2 Kbps It works together with ACTiSYS IrDA PC RS232 Dual head adapter IR910D You will need a real DOS system with at least one free COM port It does not decode OBEX or any other layers above IrLMP But all the information are preserved for you to read Please see the sample output LOG_LMP TXT attached This sample is an OBEX session Timing inform...

Страница 2: ...DA signal itself as received by IR910D The next two bytes is the 16 bit integer representing the time interval between this IrDA byte and the previous one The unit of time is 43 58 usec II Translate To Text Files Run XLATE EXE to translate LOG_RAW BIN into LOG_PHY TXT LOG_PHY TXT and LOG_LMP TXT files III Viewing The Text Files You may use any editor or word processor to view the ASCII text files ...

Страница 3: ... usec 351 means 350 usec 402 means 4000 usec 123 means 12000 usec etc d Last but not least the frame_ is an arbitrary sequential number assigned to each frame All three text files share the same sequence so that you can use it to cross reference them IV Example Using Device Embedded with IrDA Protocol IC ACT IR8200L a The first IR traffic record 1 Run COM_12 exe COM_1 exe or COM_2 exe 2 Turn on th...

Страница 4: ... c The third IR traffic record 1 Keeping IR8200L power on 2 Run COM_12 exe 3 Remove Device B and then place Device A HP Jornada 4 Active IR service program under Device A 5 You can see on the DOS screen 6 Stop listening program the program will generate a BIN file LOG_RAW BIN 7 Rename LOG_RAW BIN to REC3 BIN END Another device can link with IR8200L Device B IR8200L ACT IR910D1 ACT IR910D2 To PC Co...

Отзывы: