Action Sports S001049, Руководство пользователя

Страница: 18 / 32

©
ACTION SPORTS EQUIPMENT PTY LTD – www.actionsports.com.au Page: 18
SECTION 1 – FORT ASSEMBLY
Figure 1: Slide sand pit stays x 4 (D61) through each of
the side sleeves of the sand pit floor (B23). Place lower
main frame tubes x 4 (D60) on the four corners of the sand
pit floor, using one person to hold the poles vertically while
second person attaches components. Place ground support
pegs x 4 (X20) in corners, and attaches to lower main
frame tubes using (F3) bolt and nut x 4.
Attach sand pit stays
(D61) in all four corners to lower main frame
tubes (D60),
using (F2) bolt and nut x8. Double check fort is in correct
position and push ground support pegs firmly into the
ground.
Figure 2 : Place sand pit cover over sand pit (B24).
Figure 3: Place Middle main frame tube D62 side by
side as shown in diagram.
Connect the four middle main frame tubes with
connection pieces D64 (x2) and D65 (x2) as shown. Add
upper main frame tube D68 (x2) as shown and connect
to middle main frame tubes. The two D68 pieces must
be on the same sides (parallel to) as the two D65 cross
pieces. Connect piece D64 on remaining side before
adding nuts and bolts.