FIG #2: DUAL THRUSTER CONNECTIONS (MODE 2)
(Power connections omitted for clarity)
BOW
Commercial thruster units
STERN
Suppressor
ACTion RFI
Kits
FIG #1: TYPICAL TWIN MOTOR CONNECTIONS (MODES 1, 3 &4)
Mix control - See diagrams above
thruster e.g. Graupner
movement to thruster
clockwise
turned fully
Start with Mix
and adjust Mix slowly
= 7.2v, Robbe = 6v
that specified for the
until Voltage reaches
Apply full stick
0 - 20V
across thruster
read 0v - 20v
set scale to
motor brushes;
multimeter
Connect digital
ACTion RFI Suppressor Kit
(Power connections omitted for clarity)
when the main drive motors rotate in opposite direction e.g. At Full Ahead speed.
When connected as shown, the LEDs will both glow the same colour
MOTOR #2
MOTOR #1
"+ve"
"+ve"
STARBOARD
PORT
ADJUSTING Mix control where
Main battery voltage is greater
"+ve"
"+ve"
ACTion P95/2 Indicator
Fuse Board
ACTion P95/2 Indicator
Fuse Board
C 2023 Action R/C Electronics
Original drawing by Dave Milbourn
P94
Adjust rudder trim lever of transmitter until the two LEDs “fire up” together when
slight forward throttle command is given (does not apply to Mode 1).
than bow thruster voltage.
2023 updates by Iain Lewis
Recovery Service.
A recovery or repairs service means that you will not be left with a dead unit for any reason.
The cost of this service (as of March 2023) is £19.95 which includes the return shipping costs to any UK
address.
Should you need a repair, please contact us before sending your unit & we will explain the steps.
Either contact us by phone, or e-mail to [email protected]
www.action-electronics.co.uk
01248 719353
