Click & Go Extreme Cold Chain EU868 Quick Starter Guide – V1.0
9
4.3
INSTALLING BATTERIES AND ANTENNA
The bakery and antenna are integrated in the device, so no manual opera2ons is needed
4.4
DEVICE INSTALLATION
The SensingLab TEM-LAB-14-NS can be mount on wall using screw or tap.
4.5
DEFAULT DEVICE CONFIGURATION
The device comes fully configured and ac2vated. Therefore, you do
not need to send any Device Key
informa2on to your ThingPark Wireless account. It is configured in Over The Air Ac2va2on mode (OTAA).
The device is aiming to send a message every 10mn.
4.6
DEVICE ACTIVATION
To ac2vate the Senlab device, you have to use a magnet (min pulling force 1Kg).
§
Remove the magnet as soon as the LED flashes !
§
If ac2va2on fails (No solid LED ON 2sec), Senlab will come back in storage mode.
§
Aaer successful ac2va2on, device will automa2cally send its START message
Activation of the device
To activate the Senlab device, you have to use a magnet (min pulling force
1Kg).
✓
Remove the magnet as soon as the LED flashes !
✓
If activation fails (No solid LED ON 2sec), Senlab will come back in
storage mode.
✓
After successful activation, device will automatically send its START
message
Put Magnet
1 sec
LED blinking up to 10s
(connection status...)
LED ON 2sec
= device
ACTIVATED
Once activated, if you pass the magnet one more time, the device will
indicate its activation status after 3s LED blinking:
--> Solid LED ON 2sec will confirm that device is activated
If you want to restart your Senlab, you have first to deactivate it:
--> Send Downlink request STOP application via your LoRa system
--> Switch off with magnet can be activated for test devices,
please contact your distributor.
Status LED
MAGNET
area
Activation of the device
To activate the Senlab device, you have to use a magnet (min pulling force
1Kg).
✓
Remove the magnet as soon as the LED flashes !
✓
If activation fails (No solid LED ON 2sec), Senlab will come back in
storage mode.
✓
After successful activation, device will automatically send its START
message
Put Magnet
1 sec
LED blinking up to 10s
(connection status...)
LED ON 2sec
= device
ACTIVATED
Once activated, if you pass the magnet one more time, the device will
indicate its activation status after 3s LED blinking:
--> Solid LED ON 2sec will confirm that device is activated
If you want to restart your Senlab, you have first to deactivate it:
--> Send Downlink request STOP application via your LoRa system
--> Switch off with magnet can be activated for test devices,
please contact your distributor.
Status LED
MAGNET
area
