actiLib Autoloader 1U
– User and Service Guide
Page 26 of 97
6.10 Connecting the SCSI and power cable
INFORMATION
The LTO3 and LTO4 tape drives are Ultra 160 or 320
SCSI LVD device. Only cables and terminators specified
for Ultra160 or 320 use or labeled as Multi Mode should
be used.
WARNING
Use approves power cords!
Not doing so can result in the following:
not meeting individual country specific safety
requirements;
insufficient conductor amp capacity that could
result in overheating with potential personal
injury and/or property damage;
an unapproved power cord could fracture
resulting in the internal contacts being exposed,
which potentially could subject the user to a
shock hazard. Manufacturer disclaims all liability
in the event a non-manufacturer approved
power cord is used.
Manufacturer disclaims all liability in the event a
non-manufacturer approved power cord is used.
CAUTION
Failure to remove the power cables from these devices
when installing SCSI cables could result in damage to
the loader.
To connect the SCSI and power cable to the tape loader:
1.
Shut down and turn off the selected server. Turn off all attached devices, such as printers
and other SCSI devices. Remove the power cables from the server and all attached
accessories.
2.
Attach one end of the SCSI cable (included in the accessory package) to one of the
connectors on the back panel of the loader (see
Figure 63 Attaching the SCSI cable to the drive
