10
Changing Therapy Modes
1. Check the device is in IC Mode
2. Enter the Therapy Mode Menu
(see STEP 1
on page 11). Turn the device on by pressing
and releasing the on/off button .
by pressing
the and TIMER buttons
. The display flashes “MODE
MENU” as confirmation.
together at the
same time
Interferential Mode
3. Press or to select the desired
program
4. If you choose the variable user
programmed mode (VAR)
5. Save your VAR program parameters and
exit Therapy Mode
from the table opposite. If you
choose a preset program press and hold
TIMER to confirm your selection and exit
the Therapy Mode menu.
you will need to
set the treatment parameters in the following
order: Carrier frequency, Base Amplitude
Modulated Frequency (AMF), Peak AMF,
Sweep pattern. See the diagram above right.
Scroll through parameters using the TIMER
key and alter the parameter value using the
or keys.
Pressing the TIMER key continuously will
cycle through the parameters so you can
make any changes or check them.
menu by pressing and
holding the TIMER
button. To cancel the
new settings press and TIMER together.
You can check the settings by swithcing the
device off and on using .
Example Screen
Variable (VAR) Mode Menus
Parameter
Carrier Frequency
2kHz or 4kHz
Base Amplitude
Modulated
Frequency (AMF)
0Hz - 250Hz
Peak Amplitude
Modulated
Frequency (AMF)
0Hz - 250Hz
Sweep Pattern
6^6, 6/6, or 1/1
Sweep Pattern Options
Peak
Peak
Peak
Base
Base
Base
0
0
0
5
1
6
1
6
11
17
12
2
12
18
18
3
Time (seconds)
Time (seconds)
Time (seconds)
A
M
F
A
M
F
A
M
F
6/6
1/1
6^6
For a constant sine wave output at
the carrier frequency, set peak and
base at 0Hz in VAR mode.
If you see the timer
screen instead of the
mode menu, you did
not press &
together. Press
to exit & try again.
5
Содержание TENS
Страница 1: ......
