ACTSmart Operating and Installation Manual
Rev 1.1
- 13 -
Find Door Number:
Step
Keypad Entry
Operation
1
61
Find Door Numbers
2
1-8
Enter the door number to be found. The ACTSmart assigned the
door number starts to beep.
3
Press a key or present a
card
To stop the ACTSmart beeping
Find All Door Numbers:
Step
Keypad Entry
Operation
1
62
Find Door Numbers
2 Press
✔
Each ACTSmart beeps their door number
3
Press key or present card
at each ACTSmart
To stop the ACTSmart Beeping
Adding a Slave to the Network
Another Slave can be added to the network by defaulting it first (see below) and then assigning it a door
number from the Master.
Removing a Slave from the Network
To remove a Slave unit from the network, simply disconnect it from the network.
Replacing a Slave Unit
To replace a Slave Unit, remove the old Slave from the network. Default the new Slave and add it to the
network. Assign a door number to it from the Master.
Replacing the Master Unit
If the Master Unit needs to be replaced, then replace it with a Slave unit already on the system, (as it will
have all the card/PIN information), and make it the Master. Add a new, defaulted Slave to the network in
place of the swapped-out Slave. Then assign a Door numbers to the new Slave – make sure it is the Door
number of the old Slave.
Restoring Factory Defaults
Restoring Factory Defaults
Restoring Factory Defaults
Restoring Factory Defaults
Enter Programming code followed by 80 followed by
✔
. If this is done on the Master ACTSmart then all
ACTSmarts on the network are defaulted (including the Master). If it is done on a Slave then only the
Slave is defaulted.
If the programming code has been forgotten, power up with the
tamper open
(by removing the main unit
from the mounting plate or the surface mount collar), while holding down the
✘
key. Release the
✘
key
and then enter the default Programming Code (9999).
Defaulting memory takes 3-4 seconds. During this time, the buzzer will sound an elongated tone.