Pin & Prox Reader:
ACT5prox
Proximity Card:
ACTProx ISO-B
Proximity Fob:
ACTProx Fob-B
Proximity Half Shell Card:
ACTProx HS-B
Proximity & Magnetic Stripe Card:
ACTProx DUO-B
ACT5prox Operating and Installation Instructions
2
Installation Notes
• Remember to Factory Default the ACT5prox before programming
• Remember to place the supplied varistor across the terminals of the door strike coil to protect the relay
contacts
• Don’t mount the ACT5prox units near RF sources (Eg mobile phones, radio transmitters, computer
monitors) or metal surfaces.
• Don’t power the unit from a switch-mode power supply. Use a linear regulated power supply.
• Never use the on-board relay to switch AC mains voltage. An external relay, electrically isolated from
the ACT5prox should be used for this purpose
• Remember to change the programming code.
• When ordering new cards or fobs specify ACTRFID. ACT5prox will NOT work with HID cards or
fobs.
Important
As with any Access Control system, always ensure there is an alternate means of escape in the event of
the unit failing to operate due to power loss or in the event of fire.
Product Specification
Number of Users
50 (50 unique PINs and 50 Cards)
Supply Voltage
12 - 24V AC or DC (linear PSU)
Current Consumption
60mA (nominal), 100mA (maximum)
Operating Temperature
-10 to +50 degrees C
Door Open Time
0 - 255 seconds
Relay Contact Rating
5A / 500Vac
Controller Size
Flush Mount 100 x 110 x 20 mm
Surface Mount: 100 x 110 x 35 mm
Controller Weight
200 grams
Water Resistance
High IP67
Construction
Rugged Polycarbonate housing with stainless steel keys
and potted electronics.
Ordering Information
Act 12pp ACT5prox:Act 20pp 1.1 English 14/11/2007 13:10 Page 2
