24
8. GLOBAL REMOTE CONTROLLER (PAC-204RC)
CONFIRMATION OF PARTS
The following parts are contained in the carton box together with this manual.
Please check to make sure that everything is included.
Q’TY
À
Remote controller (upper case, lower case) ..............................................................1
Á
Pan-head screw with cross hole M4 .........................................................................2
Â
Wooden screw 4.1 X 16 (for installing unit directly on a wall .....................................2
Ã
Instruction manual .................................................................................................1
OUTLINE AND INSIDE DRAWING
INSTALLATION
(1) Decide where you want to install the remote controller (switch box)
In deciding, please observe the following precautions:
Do not install the remote controller in locations, which are:
•
Exposed to direct sunlight
•
Susceptible to humidity and moisture
•
Near a source of heat
•
Near machines emitting high-frequency waves. (High-frequency welders, etc.)
1)
Procure the following parts locally : Switch box for two units
Connecting wire (Length : below 20m size : 0.3mm ~ 0.75mm)
Lock nut, bushing
(2) Install the lower case on the switch box.
Caution :
•
Over-tightening the screws can cause
deformation and/or cracks on the lower
case.
•
Install the remote controller on a wall
with flat surface. Installation on an
uneven surface can cause cracks on
the LCD and other failures.
Snap the upper case into place. Hook the two
upper claws into their slots, and shut the lower
part as shown in the right diagram.
Caution :
•
Press the case until it snaps shut.
•
To use, remove the protective sheet on
the operation section.
To remove the upper case, insert a
screwdriver(-) into one of the slots and
side it in the direction of the arrow
shown in the diagram on the right
Caution :
•
Do not turn the screwdriver while it is
inserted into the slot. Doing so can
result in damage to the slot.