ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
17
5. Setting up the device
15
Menu level
Parameterisation level
Zero point slowdown,
ZErO:
Default:
00
At the zero point slowdown, a value range around the zero point can be preset, so the display
shows a zero. If e.g. a 10 is set, the display would show a zero in the value range from -10 to
+10; below continue with -11 and beyond with +11. The maximum adjustable range of value is
99.
Display,
dISPL:
Default:
actua
With this function the current measuring value, the min/max-value, the totaliser, the process-
controlled hold-value, the sliding average value, the constant value or the difference between
constant value and current value can be allocated to the display. With
[P]
the selection is
confirmed and the device changes into menu level.
Brightness control,
Light
:
Default:
15
The brightness of the display can be adjusted in 16 levels from 00 = very dark to 15 = very
bright via this parameter or alternatively via the navigation keys from the outside. During the
start of the device the level that is deposited under this parameter will always be used, even
though the brightness has been changed via the navigation keys in the meantime.
Display flashing,
FLASH:
Default:
no
A display flashing can be added as additional alarm function either to single or to a combination
of off-limit condition. With
no
, no flashing is allocated.
