Acrosser Technology AR-B1684VL, Руководство по эксплуатации

Страница: 30 / 51

~ Page 26 ~
HDD Access Control
This option determines the hard disk access method, which can be either read only or normal (read/write).
When set to read only, the data in the hard disk is being read instead of being written.” Normal” allows the
floppy to be read or written.
Available options: Disabled, Enabled
S.M.A.R.T for hard Disks
S.M.A.R.T is abbreviation of Self-Monitoring Analysis and Reporting Technology .It is reliable and
precautious technology. When Hard Disk disorder, It prevents Hard Disk from the loss of data.
BootUp Num-Lock
This item is used to activate the Num-Lock function upon system boot. If the setting is on, after a boot, the
Num-Lock light is lit, and the user can automatically use the number keys.
Floppy Drive Swap
The option reverses the drive letter assignments of your floppy disk drives in the Swap A, B setting,
otherwise leave on the setting to
Disabled (No Swap). This works separately from the BIOS Features floppy
disk swap feature. It is functionally the same as physically interchanging the connectors of the floppy disk
drives. When <
Enabled> , the BIOS swaps the floppy drive assignments so that Drive A becomes Drive B,
and Drive B becomes Drive A under DOS.
Floppy Drive Seek
If the <Floppy Drive Seek> item is set to Enabled , the BIOS will seek the floppy <A> drive one time upon
bootup.
PS/2 Mouse Support
The setting of Enabled allows the system to detect a PS/2 mouse on boot up. If detected, IRQ12 will be
used for the PS/2 mouse. IRQ 12 will be reserved for expansion cards if a PS/2 mouse is not detected.
Disabled will reserve IRQ12 for expansion cards and therefore the PS/2 mouse will not function.
Typematic Rate
This item specifies the speed at which a keyboard keystroke is repeated.
System Keyboard
The setting of < Absent > allows the system to boot without a keyboard attached to the computer and the
setting of <Present> is in the contrary.
Primary Display
The setting of
< Absent > allows the system to boot without a Primary Display attached to the computer and
the setting of <Present> is in the contrary.
Password Check
This option enables password checking every time the computer is powered on or every time the BIOS
Setup is executed. If
Always is chosen, a user password prompt appears every time the computer is
turned on. If Setup is chosen, the password prompt appears if the BIOS are executed.
Boot to OS/2 >64MB
When using the OS/2 operating system with DRAM of greater than 64MB installed, you need to Enabled this
option; otherwise leave this on the setup default of Disabled .
Wait for ‘F1’ If Error
AMIBIOS POST error messages are followed by:
Press <F1> to continue
If this option is set to Disabled , the AMIBIOS does not wait for you to press the <F1> key after an error
message.