Recorder M4000 Operation:
The reader has a luminous indicator called LED (light emitting diode) and a Buzzer.
To install battery:
Open the top of your reader and connect a 9 volt battery, preferably alkaline. If the battery is in good shape the LED will emit 2
green
blinks
with two beeps, followed
by one green blink with a
beep
.
To make a recording:
To effect recordings of Recording Stations, ID Keys, Incident Booklets, (any iButtons) you need only to touch them with the
reader’s probe. If a correct recording is effected the reader will emit two continuous
green blinks
each with a beep.
Low battery:
During recording operations (with each recording) a low battery status will be advised by the recorder M4000 by emitting
2 red blinks each
with a beep. This means you will have to change the battery soon.
A dead battery will be advised with
1 red blink
with a beep.
Full Memory:
When the memory of your reader reaches “full” status (5460 recordings), each time you attempt a recording, the reader will emit
4 red
blinks
each with a beep;
this means your recorder is not reading anymore. For this case please effect a full download of data to your PC and then erase
the memory to reset; now your reader will be ready for the next load cycle of 5460 new recordings.
(Recorders Tab):
Here is where you setup and register your M4000 Recorders to the Ares III System. Each recorder comes labeled with a factory programmed 16 charac-
ter serial number. This will enable the user to view
(discern)
in the
Recordings
folder, all the recordings effected by each recorder and guard. Here
again! who, when, what and how is critical in the security business.
How to add a new Recorder to your System:
1.) Select the
Recorders
Tab
2.) Connect your Recorder to your PC’s serial RS232 port. This port must be free (not in use).
3.) Select the
NEW
button.
4.) Select the appropriate (correct) RS232 free port (not in use). Ex. 1,2,3, Etc.
5.) The serial number of your Recorder will be displayed.
6.) Key in the Recorder’s name or number (off your own choosing).
7.) Press
OK
.
Memory Delete (Reset)
1.
Connect your Recorder to your PC’s serial RS232 port. This port must be free (not in use).
2.
Select the
Recorders or the Recordings
Tabs (either of the two).
3.
Press the
Download / Program
button
.
4.
Make sure the correct RS232 is selected. Ex. 1,2,3, Etc.
5.
Select
ID
.
6.
And finally select
Delete
.
This procedure will delete/reset your recorder’s memory.
Содержание ARES III
Страница 19: ...Booklets Keypads assignment...
Страница 21: ......
Страница 24: ...Filtered Report...
Страница 30: ......
