14
Copyright © Acronis, Inc., 2000-2010
partition:[partition number]
Specifies the partitions to restore.
Dynamic volumes are specified with the prefix DYN, e.g.:
/partition:DYN1
target_harddisk:[disk number]
Specifies the hard disk number where the image will be restored.
By specifying
/target_harddisk:DYN
you will select unallocated space on all dynamic disks that are present in the system.
target_partition:[partition number]
Specifies the target partition number for restoring a partition over the existing one. If the option is
not specified, the program assumes that the target partition number is the same as the partition
number specified with the /partition option.
Dynamic volumes are specified with the prefix DYN, e.g.:
/target_partition:DYN1
start:[start sector]
Sets the start sector for restoring a partition to the hard disk unallocated space.
size:[partition size in sectors]
Sets the new partition size (in sectors).
fat16_32
Enables the file system conversion from FAT16 to FAT32 if the partition size after recovery is likely to
exceed 2 GB. Without this option, the recovered partition will inherit the file system from the image.
type:[active | primary | logical]
Sets the restored partition active, primary or logical, if possible (for example, there cannot be more
than four primary partitions on the disk). Setting a partition active always sets it primary, while a
partition set primary may remain inactive.
If the type is not specified, the program tries to keep the target partition type. If the target partition
is active, the restored partition is set active. If the target partition is primary, and there are other
primary partitions on the disk, one of them will be set active, while the restored partition becomes
primary. If no other primary partitions remain on the disk, the restored partition is set active.
When restoring a partition on unallocated space, the program extracts the partition type from the
image. For the primary partition, the type will be set as follows:
