ADDITIONAL SAFETY PRECAUTIONS
Wear safety glasses at all times when working with pumps.
12.
13.
14.
15.
PREPARATION
WARNING
WARNING: Always use handle to lift pump. Never use power cord to lift pump. To avoid skin
burns, unplug and allow timefor the pump to cool after periods of extended use.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time (New installation): 5 minutes
Materials Required for Assembly (not included): Garden Hose or Hose Kit
The pump should rest on a level, solid base.
Do not suspend the pump by the discharge hose or power cord.
Keep the pump inlet screen clear.
Do not install pump directly on sand or dirt. A minimum water level of 1 in. is required to prime
the pump.
INSTALLATION INSTRUCTIONS
Attach a 5/8 in. inside diameter or larger garden hose
(not included)to the pump (A) outlet.
Note:
Be sure the hose end has a rubber washer to
minimize water leaks.
Follow all electrical and safety codes, particularly the National Electrical Code (NEC) and in
the workplace, the Occupational Safety and Health Act (OSHA).
This unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with an
approved 3-conductor cord and 3-prong grounded plug. DO NOT REMOVE THE GROUND PIN
UNDER ANY CIRCUMSTANCES. The 3-prong plug must be directly inserted into a properly
installed and grounded 3-prong, grounding-type receptacle. Donot use pump with a 2-prong
wall outlet. Replace the 2-prong outlet with a properly grounded 3-prong receptacle (a GFCI
outlet) installed in accordance with the National Electrical Code and local codes and
ordinances. All wiring should be performed by a qualified electrician.
Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking
the cord. Do not use damaged or worn cords.
Make certain the electrical circuit to the pump is protected by a 10-amp or larger fuse or circuit
breaker.
Periodically inspect pump and system components, to be sure pump inlets are free of mud, sand
and debris. DISCONNECT PUMP FROM THE POWER SUPPLY BEFORE INSPECTING.
10.
11.
1.
1
A
4
