Introduction
Introduction
The scope of this Startup Guide is to detail the processes of receiving and installing the
Acqiris SA217P signal acquisition card, installing the required software, and verifying basic
card operation.
If you have any questions after reviewing this information, please contact technical support
Closely follow the startup process flow in this document. Deviating from the sequence can
cause unpredictable system behavior, damage your system, and may cause personal
injury.
Step 1: Unpack and Inspect the Card
The card is shipped in materials which prevent damage from electrostatic discharge. The
card should only be removed from the packaging in an anti-static area ensuring that
correct anti-static precautions are taken. Store all cards in anti-static pouch when not in
use.
Electrostatic Discharge (ESD) Precautions
Electrostatic discharge (ESD) can damage or destroy electronic components. Use a static-
safe work station to perform all work on electronic assemblies. A static-safe work station
uses, for instance, two types of ESD protection: conductive table-mat and wrist-strap
combination, and conductive floor-mat and heel-strap combination. Both types, when used
together, provide a significant level of ESD protection. Of the two, only the table-mat and
wrist-strap combination provides adequate ESD protection when used alone. To ensure user
safety, the static-safe accessories must provide at least 1 MΩ of isolation from ground.
DO NOT use these techniques for a static-safe work station when working on circuitry with
a voltage potential greater than 500 volts.
Inspect for Damage
After unpacking the SA217P card, inspect it for any shipping damage. Report any damage to
the shipping agent immediately, as such damage is not covered by the warranty (see
warranty information attached to the original quote or order confirmation from Acqiris).
8
Acqiris SA217P Startup Guide
