5
Step 5
Adjust the clearance underneath the acrylic arm,
so that the acrylic arm is horizontal.
Step 6
Slide the UNI-P2S into place in the direction of
the tonearm’s bearing house/pivot.
Step 7
Do mount the long stainless steel positioning pin
with the reticule either on top or pointing down
-
ward into the nylon tunnel. It will fit quite tight
- handle with care, as the tip is sharp and may
cause injuries. Do untight the black screw on the
POM-block carrying the metric scale. Slide the
metric arm with the pin toward the center of the
arm bearing house.
If you can spot the center, use the pin-point.
Try to locate pin exact over the pivot center.
If unsure of pivot center, do use the reticule and
determine pivot center by finding symmetrical
outer lines on the bearing house.
Step 8
When pivot center is directly underneath the pin,
do fasten the screw holding the metric scale in
place.
Now look on the scale on the POM block.
