8
EN
Sharing WiFi settings from your
iPad, iPhone, or iPod touch
If your device has iOS 5 or later installed, you
might be able to use WiFi setup sharing to setup
the ARAP50.
1. Connect your iPad, iPhone, or iPod touch to
the USB port on the ARAP50 with USB sync
Cable.
2. When the ARAP50 is powered, press the
Set
Up
button on the back of the ARAP50 (next
to the USB port).
3. The screen of your iPad, iPhone, or iPod touch
will show the following prompt:
Share WiFi
Settings?
Select "Allow" to proceed with WiFi
setup sharing. The ARAP50 will restart.
4. Wait for the
Network
indicator on the front of
the ARAP50 to turn green. You are now
connected. If after going through the setup
process the
Network
indicator is flashing red,
the ARAP50 has not properly connected to
your WiFi network. Please repeat the setup
process or see Troubleshooting for more info.
Setting the network parameters
manually (Setup on PC or Mac)
Enter Set Up mode
1. Press
Power
to turn on the unit. The
Power
indicator will be flashing in alternating blue
and red.
2. After successful boot-up, the
Power
indicator
will turn to solid blue. Press and hold the
Set
Up
button on the back of the ARAP50 for
three seconds to enter Set Up mode. ARAP50
will restart. Wait until the
Network
indicator
on the unit begins to flash green. If the
Network
indicator flashes red continually,
press
Power
to turn off the unit and try again
from step 1.
Connect to your audio system with WiFi
1. Enter the list for selecting wireless network
on your PC or Mac. Alternatively, select
Settings>WiFi
on your iPad, iPhone, or iPod
touch.
Make sure your iPad, iPhone, or iPod
touch is installed with the iOS 4.3.3
(or later) or iTunes 10.2.2 (or later).
Refer to the List of compatible iTunes host
devices for AirPlay in the Before you Begin
section for details.
2. The
audio system will appear as
ARAP50
setup XXXXXX.
(the “
XXXXXX
” are numbers
that uniquely identify the particular unit you
have). Select
ARAP50 setup XXXXXX
from
the list of available networks.
ARAP50 setup 010434
If
ARAP50 setup XXXXXX
is not in
the list, refresh and scan the available
WiFi networks again.
Launch and follow Set Up steps in your web
browser
1. Once your device has been successfully
connected to the
ARAP50 setup XXXXXX
wirelessly from your list of available WiFi
networks, launch
Safari
browser or any other
Internet browser on your PC, Mac, iPad,
iPhone, iPod Touch.
2. Type
in
192.168.10.1
at the browser address
bar and confirm. The configuration web page
of ARAP50 will be displayed.
http://192.168.10.1
3. Select
Wireless Set Up
on the left hand
column.
4. If you wish to change the default name of
ARAP50, enter the name you'd like to give the
ARAP50 in the box of
Name your Audio
System
and then click
Apply
.