Arrange the following cables in their maximum lengths to the panel:
2 wires x 1mm
2
- power supply
2 wires x 0.75mm
2
- to E-lock
UTP (standard T568B) - bus, max. 70m - from the panel (or the last power supply unit), 300m in total - when using
additional power supplies.
If cross-sections are smaller and connections that are too long, voltage drops may occur, causing the panel to malfunction.
To extend the length of cables, their cross-section must be increased.
WIRING DIAGRAM
Note!
If the system features only one monitor, no video splitter is necessary
and the monitor is connected at the end of the UTP bus leaving the
panel. It is then absolutely necessary to connect the monitor power
supply by connecting the bus cable: orange and brown together to
"+DC" terminal of the panel (in this case the maximum distance
between the panel and the monitor is 70m). When using Video splitters,
cable length may be extended up of 300m from the panel to the monitor,
assuming that the splitter, with a power supply
A
to it - is within 70m
from the monitor. (It is then not required to connect the orange and
brown wires to the panel -
it’ enough to use jumper J1 on the splitter).
MONITOR INSTALLATION AND CONNECTION
When installing the monitor refer to the user instruction delivered with the monitor.
When connecting the monitor, make sure the RJ45 plug (standard T568B) is crimped. Before turning on the power, make sure that
all RJ45 plugs are properly crimped (the same way), that the wires conduct current and check for possible short circuits between the
wires. If even one RJ connector is badly crimped or in case of a short circuit between wires, the video inside unit, splitter or combiner
may be damaged.
Note!
Also make sure that addresses are properly configured in the monitor. For panels with direct
call buttons (ring buttons), button
addresses are pre-set from 1 to 6 (depending on panel model). The lowest button corresponds to address 1. If no direct button is
present buttons, the addresses of the monitors are called directly from the numeric keypad (pre-set at 1 to 10).
There may be monitors with the same addresses in the video system, which means that several monitors can call at the same time
when the call button is pressed. If have an additional indoor units, calling simultaneously with the monitor, use INS-UP720MR, UP800
indoor units. Use INS-UP720MR, UP800 indoor units also when only one indoor unit needs to be installed to call upon pressing the
call button.
INPUT
VS
VIDEO
LINE
INPUT
ELOCK
-DC
POWER
+DC
POWER
GND
max 1A
Power
15 V DC
ROZDZIELACZ
/ SPLITTER
ML
1 Orange and white
2 Orange
3 Green and white
4 Blue
5 Blue and white
6 Green
7 Brown and white
8 Brown
Power supply
Video
- Signal line (GND)
Power supply
+ Signal line (L+)
ON
Address: 1
Address: 2
Address: 3
Address: 46
ON
ON
ON
CODE/ADDRESS
CODE/ADDRESS
CODE/ADDRESS
CODE/ADDRESS
ON
OFF
