Cable Not Connected
2.4 AD Board OSD Functions
2.) Getting into Burn-in Mode
Before setting into a burn-in mode, first disconnect the AC power cord. Then press (don
‟
t let them go)
the
buttons until the AC power cord is connected and the “RGB” appears on the top lef
t corner
of your screen. Now it can be put into the burn-in mode for changing colors.
2.) Getting Out of Burn-in Mode
Before getting out of the burn-in mode, please first disconnect the AC power cord. Then press the
button (If not workable, press the
button and don
‟
t let them go) until the AC power cord is
connected. Please don
‟
t let your fingers go until the AC power cord is connected again and the
wording of
“
RGB
”
appears on the top left corner of your screen, and wait for 3 second. Under the
non-signal entry situation, if
is seen, exit is thus successfully made.
When the Burn-in Mode is Unable to
Eradicate…
4.) If the
“
RGB
”
is still on the top left corner of the screen, press
to enter
“
Miscellaneous
”
and
choose
“
Reset
”
, and then
Yes,
and press
. When the screen goes black, disconnect power and
repeat the above steps.
5.) If the
“
RGB
”
is not found, disconnect the AC power cord first. Then press the
buttons
(don
‟
t let them go) until the AC power cord is connected, and wait for 2 to 3 seconds. When
“
RGB
”
appears, repeat the above steps.
6.) Functions of OSD Keys
Auto Adjust
Up/Left Down/Right Power
Menu/Entry
Power Indicator
