www.acme-online.de
ACME the game company
described
The helicopter turns and
cannot climb
Upper rotor unit screws
loosen
Tighten the screws
The helicopter does not
gain height
Weak battery
Battery not fully charged
Battery damaged
Charge helicopter
Replace batteries of the
controller
Replace the heli battery*
The helicopter does not
react on controller
Controller batteries too
weak
Replace batteries in the
controller
The range is not sufficient
Controller batteries too
weak
Replace batteries in the
controller
One of the Motors stops
running
Motors are used up after
about 100 times of Flying
Replace (both) Motors*
The helicopter does not
charge
Range is not sufficient
You are using rechargeable
batteries inside the
controller
Only use AA batteries.
The helicopter flies
strange figures.
Stray lights
Do not fly under artificial
light
Please replace defective rotors immediately! – Pay attention on the main rotors label! A
main rotor above and B main rotor below – never place them wrong side out!
Needed spareparts you can find on page 16 or at
www.acme-online.de
Battery care and replacement
For a longer battery life, please follow the following steps :
- Never store the model in activated state. Always switch off after use.
- Make sure that the model is stored with sufficient battery capacity (min 85%)
- Always store at room temperature
- When not used for a longer time, charge the battery every 3 months.
Please follow these steps to avoid a damage on the battery.
How to install a replacement battery
1.
Remove the cockpit of the helicopter (2 or 3 screws).
2.
Cut off the 2 cables (red and black) that connect the battery with the helicopter.
3. Strip the black wire about 7 mm.
4. Strip the black wire of the new battery about 7mm.
5. Twist the wire ends together and fold over at the half.
6. Slide the supplied plastic wrap (heat shrink tube) and heat it up briefly with a lighter.
7. Please make sure that the copper wires are not visible.
8. Proceed accordingly with the red wire.
