ACME XPerior 700WZA, Руководство пользователя

Страница: 26 / 36

XP-700WZA
25A
6. 3 pin XLR connectors are more popular than 5 pins XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin4, Pin5
not used.
7.2 Channel Mode Setting
Enter menu mode, select DMX Functions , press ENTER button to confirm, use jog wheel
to select DMX Channel Mode , press ENTER button to confirm, present channel mode will
blink on the display, use jog wheel to select Mode1 (16 channels mode ) or Mode 2 (21
channels mode) or Mode 3 (21 channels mode) , press ENTER button to store. Press
MENU button back to the last menu or let the unit idle one minute to exit menu mode.
7.3 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 so that the units can receive DMX signal.
Press MENU button to enter menu mode, select DMX Functions , press ENTER button to
confirm, use jog wheel to select DMX Address , press ENTER button to confirm, the
present address will blink on the display, use jog wheel to adjust the address from 0 to 512,
press ENTER button to store. Press MENU button back to the last menu or let the unit idle
one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
16 channels 1 17 33 49
21 channels 1 22 43 64
7.4 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attention:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 seconds, then the corresponding
function will take into effect.