2C
1. Safety Instruction
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems
.
y
Unpack and check carefully that there is no transportation damage before using the unit.
y
The unit is for indoor use only. Use only in a dry location.
y
DO install and operate by qualified operator.
y
DO NOT allow children to operate the fixture.
y
Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head only.
y
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces.
y
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
y
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
y
It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
y
Maximum ambient temperature Ta: 40
℃
. DO NOT operate it when the temperature is higher.
y
DO NOT connect the device to any dimmer pack.
y
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, and it will decrease gradually within 15 minutes.
y
Make sure there are no flammable materials close to the unit while operating to avoid fire
hazard.
y
Examine the power wires carefully, replace them immediately if there is any damage.
y
Unit’s surface temperature may reach up to 85
℃
. DO NOT touch the housing bare-handed
during its operation, and allow about 15 minutes for cooling the unit down before replacing
bulb or maintenance as it could be very hot.
y
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut
off the mains power immediately.
y
DO NOT operate in dirty or dusty environment, do clean fixtures regularly.
y
DO NOT touch any wire during operation as there might be a hazard of electric shock.
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
Содержание Led Move 700PE
