4
Preparation
Compensation for recorded content
ACME will not be responsible in any case for any consequential or direct problems that will
lead to a loss of recorded or edited data. Furthermore ACME will not guarantee the content in
case the recording or saving is not working properly. The above limitations are as well valid in
case the unit has been repaired.
Do not remove the micro SD Card while recording or saving. Do not switch off or take out the
battery before the recording has been stopped or as long there is access to the memory,
indicated by a rotating circle.
Protect the unit from extreme temperatures. Stop recording at temperatures less than minus
10°C and higher than 60°C. Remove the camera from the windshield/sucking pad in case
extreme temperatures might be possible!
It is known that forged accumulators which remarkably look like the original product are
offered for the sale again and again. Some of these accumulators are not equipped with a
proper protection circuit which would satisfy the regulations of the prevailing safety
regulations. These accumulators can perhaps lead to fires or explosions. We assume no
liability for accidents, damages or failures which result from the use of a forged accumulator.
Battery charging
The inside battery is not fully charged when being purchased.
Please charge the battery before you are going to use the camera
the first time!
Connect the Docking Station with your computer using the included
USB-cable and insert the camera to charge. The charging process
is indicated by the LED and is finished after about 2 hours.
Use the original USB-Cable or the optional available power adaptor
only to charge the camera.
Exchange the Battery
Battery lock
Battery cover
Slide the lock to the top position and remove the
cover. The battery is wire connected and can be
removed by careful pulling. Insert the new battery
the same way - take care of the polarization. Only
use original battery to prevent damage of the unit.
(Art.-No.: FCHD17)
