ENGLISH
24
3D HELI Master
Technical data
Helicopter model:
Blizz 200 3D
Controller AC 2460H: 5+1 -channel
Digital Proportion RC module, 2.4 GHz
Length: 238
mm
Width: 50
mm
Height: 93
mm
Weight: 50
g
Gyro system:
Integrated
Receiver:
AR 2460 (built-in)
Range:
about 60 m
Flight duration:
4 – 5 min.
Charging time:
20 min.
Motor:
Brushed motor
Length of the rotor blades: 113 mm
Rotor diameter:
249 mm
Tail rotor diameter:
45 mm
Flight battery:
LiPo 3.7 V 300mAh 25C
USB battery charger:
LiPo Charger 1 Cell,
charging current: 0,5 Ah
FAQ
Problem Possible
Cause
Solution
LED on receiver fl ashes constantly and
no function works after switching on the
controller.
Controller and helicopter are not bound.
Bind controller and receiver (see p. 21).
The helicopter does not respond after
connecting the battery to the receiver.
Either controller or helicopter might not
be connected to power.
Check battery connections.
Batteries of either sender or receiver
might be low.
Replace and charge batteries.
When pushing the throttle the rotor does
not move and the LED on the helicopter
fl ashes constantly.
Low battery
Replace and charge the batteries.
Connection between battery and receiver
board is bad.
Reconnect the batteries and the receiver board.
Helicopter takes off as soon as batteries
and receiver are connected.
Throttle is not in idle position.
Put the throttle in idle position before switching
on the controller.
The propeller rotates constantly but the
helicopter cannot take off.
Helicopter batteries low.
Replace and charge the batteries.
Main gear loose.
Press the gear spindle tightly.
Helicopter vibrates or shakes whilst fl ying. Damaged rotor blades.
Exchange main rotor blades
The blade grips on the lateral axis are
too tight.
Loosen blade grips.
When taking off, the helicopter is out of
control.
Helicopter has not been static whilst
binding.
Rebind controller and helicopter correctly.
The sound of the main rotor slowly dies
away.
Helicopter battery low.
Charge battery.
Helicopter does not react or does not fl y
smoothly.
Failure of binding.
Rebind helicopter and controller, make sure the
helicopter stays static during the process and is
placed close to the controller.
