Aclara SGM1400 Series, Руководство пользователя

Страница: 6 / 108

iv
SGM1400 Series Smart Meter User Manual – S M E T S 2
Always de-energize and ground the equipment before maintenance. Maintenance
should be performed only by qualified personnel. The use of unauthorized parts in
the repair of the equipment or tampering by unqualified personnel will result in
dangerous conditions which will cause severe personal injury or equipment
damage. Follow all safety instructions contained herein.
IMPORTANT
The information contained herein is general and not intended for specific
application purposes. It does not relieve the user of responsibility to use sound
practices in application, installation, operation, and maintenance of the equipment
purchased. Aclara reserves the right to make changes in the specifications shown
herein or to make improvements at any time without notice or obligations. Should
a conflict arise between the general information contained in this publication and
the contents of drawing or supplementary material or both, the latter shall take
precedence.
The equipment in this manual must be operated only from the power source
specified.
The successful operation of this equipment depends upon proper handling,
installation, and operation. Neglecting fundamental installation requirements may
lead to personal injury as well as damage to electrical equipment or other property.
All electronic components within the meter are susceptible to damage from
electrostatic discharge. To prevent damage when handling this product, use
approved static control procedures.
Hazardous voltages can cause shock, burns, or death. To prevent exposure to
hazardous voltages, disconnect and lock out all power sources before servicing
and removing components.
If the meter is used in a manner not specified in this manual, the protection
provided by the equipment may be impaired.
Unauthorized changes or modifications made to the unit could void the warranty.
Qualified Personnel
For the purpose of this manual, a qualified person is one who is familiar with the
installation, configuration, or operation of the equipment and the hazards
involved. In addition, the person is:
• trained and authorized to de-energize, clear, ground, and tag circuits and
equipment in accordance with established safety procedures;
• trained in the proper care and use of protective equipment such as rubber
gloves, hard hat, safety glasses or face shields, flash clothing, etc. in
accordance with established safety practices; and
• trained in rendering first aid.
Any work on or near energized meters, meter sockets, or other metering
equipment presents the danger of electrical shock. All work on these products
must be performed by qualified industrial electricians and metering specialists
only. All work must be done in accordance with local utility safety practices and
procedures.