1
Manufacturing Inc.
ACL
ACL CSC 200 Combustion Safety Control
FEATURES
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
I
No Programming
CSA approved for Class , Div 2 location
Operational ambient temperature of -40° to +60° Celsius
CSA approved C22.2 No 199-M89. Combustion safety
controls and solid-state Ignitors for Gas & Oil burning
equipment
CSA B149.3 - 10 compliant, meets NFPA standards
Type 4x enclosure, corrosive resistant and weatherproof
100% fail safe design
Safety lockout for high temperature setting
Onboard solenoid driver for power reduction to solenoids and peak-hold solenoids
Two adjustable type K thermocouple inputs for monitoring two
separate temperature points (process temp. & high temp.)
Pilotless burner control selectable. Single and dual stage, Low fire and High fire
Shutdown input (ie. Low level shutdown, pressure shutdown)
2 Selectable thermocouple ranges of -60°C to 1100°C or 0°C to 500°C (-75°F to
2012° F or 32° F to 932° F)
Adjustable dead band from 1, 2, 3 and 5 degrees C or 2, 4, 6 and 10 degrees F
°C
° F
The ACL CSC 200 is designed to be used in conjunction with the ACL combustion
module for a complete safety combustion device. The ACL CSC 200 provides burner
ignition and flame fail, as well as monitoring of two separate thermocouple inputs which
can be utilized for temperature control in process applications such as tanks, line
heaters, re-boilers or any other application where accurate temperature monitoring or
control is required. The system is designed to operate with or without a continuous
pilot.
The two independent temperature set points can be adjusted with the three membrane
push buttons on the face of the controller with LED indication of Temp 1 or Temp 2.
Initial set up for temperature ranges,display and dead band can be obtained through dip
switch selections for various user preferences.
Easy to read four digit seven segment LED display
LED indication of thermocouple 1 or 2 values displayed
or
readout
12/24VDC and solar
Low power consumption (Power save mode operates as low as 1.2 Watts)
On/Off control
“THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I DIVISION 2, GROUPS A,B,C, &D OR NONHAZARDOUS
LOCATIONS ONLY”
“WARNING-EXPLOSION HAZARD- SUBSTITUTION OF COMPONENTS MAY IMPAIR THE SUITABILITY FOR
CLASS I DIVISION 2”
DESCRIPTION
