FINAL INSTALLATION
6.
Install the device
Place the device in an appropriate place using the wall mounting kit. The
device can be installed outside.
7.
Modifying device’s parameters
Via the integrated web management interface, set the following main
parameters:
-
The operating mode: AP mode with or without WDS, Infrastructure
bridge mode, ad-hoc bridge mode
-
Wifi security parameters (WEP, WPA, WPA-PSK, WPA2, WPA2-
PSK, MAC address filtering, SSID broadcast or not)
-
Wifi parameters: 802.11 mode, radio channel (take care about
legislation), SSID
TROUBLESHOOTING
All 8 leds indicator are OFF
-
Verify the power supply (Voltage, cabling).
The relevant LAN1 or LAN2 led indicator stays OFF
-
Verify the Ethernet plug of your network, try to connect another device.
-
Connect the device with the ACKSYS M12/RJ45 cable.
Remote WiFi clients cannot connect to the AP
-
Make sure that the clients support the Wireless parameters that the AP
is set to (SSID case sensitive, 802.11 mode, radio channel, security).
-
Check the radio conditions : distance, placement of antennas.
-
Temporary disable all securities and encryption settings.
-
Try another radio channel.
WlanTX/RX and diag leds are flashing in bridge mode
-
This means that the bridge is out of range of AP.
“ACKSYS NDM” doesn’t find your device
-
ACKSYS NDM only scans the local network. Devices located behind a
gateway are not seen.
-
If you use a firewall on your P.C, check if the application is not blocked.
How to restore factory settings
-
If the built-in web-based interface is reachable, you can use your
browser to restore factory settings.
-
Open the case of the unit, and reset unit back to factory default by
holding down the reset button for at least 2 seconds while the unit is
powered on.
-5-
