Documentation ref DTUS075 rev A0 06/18/20
-3-
NOMENCLATURE
SWA
A10
33
-
42
0
X0
1
2
3
4
5
6
1 – Enclosure
SWA Aluminium polyester powder coated
SWS Stainless steel AISI 316 (CF8M) electropolish
4 – Cable entries
42 n° 4 3/4” npt-f (two used for antenna connection)
44 n° 4 M25x1.5 (two used for antenna connection)
2 – Device code
A10 802.11n, MIMO 2x2
A11 802.11ac, MIMO 2x2
A12 802.11n, MIMO 2x2 plus 802.11ac (1 stream)
5 – Colour
0 black polyester powder coating (SWA series only)
E electropolished (SWS housings only)
3 – Antenna connection
30 n° 3 RXN antenna coupler (N Female)
33 n° 2 RXN antenna coupler (N Female)
6 – Approvals
X0 Atex/IECEx Gas and Dust certified, Zone 1, 2, 21 & 22
M0 Atex/IECEx Gas, Dust and mining certified, Zone 1, 2, 21 & 22
N0 QPS CL1 DIV1 and North American Zones listed
PRODUCT’S STORAGE
Keep the boxes away from atmospheric agents in an environment with
temperature between 0°C and 40°C.
INSTALLATION
Attach the enclosure to a fix surface using four M6 bolts
The unit can be installed in all position.
ELECTRICAL WIRING
Remove screw cover, remove protection plugs from cable entries and
substitute them with cable glands or conduits or plugs suitable for type of
protection required.
Connect terminal strip according to the wiring diagram present into the Annex
to Installation & Operation Manual.
Reassemble screw cover and lock it by means of the screw or anti rotation
kit.
WARNING: Before closing the enclosure check that thread joint were free of
foreign matters and deformations check seal is properly fitted in slot.
The cover must be screwed and securely locked to the body.
MAINTENANCE
The verification and maintenance of the electrical equipment must be
performed according to IEC/EN 60079-17.
The cover must be securely locked to the body.
After every opening must to check before closing
that he thread joint is free of foreign matters and
deformations and if necessary lubricate the thread
joint in order to avoid cover blocking with grease
like Nyogel 760G, Uniflor 8512R, Uniflor 8911
compatible with silicon gasket or equivalent
according to enclosure temperature range.
In order to guarantee the protection degree IP66-
68 it’s necessary that the gasket is maintained in
good conditions and must be verified after every
opening that the same does not show breakage or
cuttings. In case of damage replace with ACKSYS spare part.
The maintenance related the components used for wiring must be performed
according to manufacturer instruction.
DISPOSAL / RECYCLING
Disposal and recycling of the product according to national regulation for
waste disposal and recycling.
WARNING: Do not dispose the product and the components in the
environment.
