Acksys AirLink V2, Быстрое руководство по установке

Страница: 22 / 40

-2-
HARDWARE INSTALLATION
1. Plug the antennas in

Plug the 2 antennas of your choice into the Ant.1 and Ant.2 connectors.

For single antenna installation, use Ant.1 connector.

For dual antenna installation, use Ant.1 and Ant.2 connectors.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput.
2. Connect the power supply
See the “ specifications ” section about the characteristics of the power supply.
The device has 2 sources of power supply:
- DC power through power connector
- PoE through LAN connector
The device has no ON/OFF switch. It turns-on automatically when power is applied.
Check LED Power
ON if DC power supply or PoE source is ON.
The Diag LED stays red for around 60 seconds, until the device is fully ready to use. Then
the Diag LED turns green.
Connect the device to the ground with a braided metal wire, fixing on the lug.
3. Connect the Ethernet cable

Plug the Ethernet cable to the device’s LAN connector.

Check that the corresponding LAN LED turns ON at that point.

If the device is powered by a PoE source, use LAN connector.