Acksys AirBox V1 Series, Быстрое руководство по установке

Страница: 26 / 36

-8-
‘WiFi Ant’ antenna connectors (50 ohms)
RP SMA female connector
Center pin
A
L
L
A
I
R
B
O
X
s
First WiFi interface (2T/2R)
WiFi/WiFi1 Ant1 : RF connector for
the 1
st
antenna
WiFi/WiFi1 Ant2 : RF connector for
the 2
nd
antenna
If unused, keep it open.
A
I
R
B
O
X
/
1
2
2
nd
WiFi interface (3T/3R)
WiFi2 Ant1 : RF connector for the
1
st
antenna
WiFi2 Ant2 : RF connector for the
2
nd
antenna
WiFi2 Ant3 : RF connector for the
3
rd
antenna
If unused, keep it open.
To get the highest benefit of the MIMO
technology and its high radio bit rate,
you must connect all antennas (2 in
2T/2R and 3 in 3T/3R).
Nevertheless, in degraded mode, it is
possible to connect a single antenna
for a 2T/2R interface (use exclusively
Ant1 connector) or 1/2 antennas for a
3T/3R interface (use exclusively Ant1
connector or Ant1/Ant2 connectors.
Cellular Main/ Aux antenna connectors (50 ohms)
AirBox/14 only
SMA female connector
Center hole
2 connectors:
•
Cellular Main Ant.
•
Cellular Aux Ant.
Using Cellular Aux Ant. is optional.
When connected, it is used for Rx
diversity to improve the quality of the
received signal.
If unused, keep it open.
GNSS antenna connector (50 ohms)
AirBox/14 only
SMA female connector
Center hole
AirBox/14: One connector (GNSS Ant.)
No GNSS antenna is provided.
Use only active antenna. Using passive
antenna may damage the interface.
Antenna gain is controlled by a DC
output voltage of 2,85V.
If unused, keep it open.