12
JUNIOR / JUNIOR PRO - ALVÉO’NOX - NEW JET VAG - PRO LUXE - LUM JET VAG
2.
mounting
the
facade
pic 1
pic 3
pic 4
pic 5
pic 6
•
After the installation of the sealing part (see:
manuel: Sealing part), remove the protection
plate
(pic 1)
•
Identify the two outputs at the back of the
part to be sealed
(pic 2)
:
The output 1 with a foam (filter) represents
the air tube. Place it above the water level,
in the open air
(pic 3)
For a pneumatic control, output 2 allows
the control tube to pass through. The latter
must connect the electrical box to the
button on the façade (
pic 3
)
For an electrical control, output 2 allows
the passage of the piezo cable. The latter
must connect the electrical box to the piezo
button
.
Tip: To facilitate assembly of the control tube,
insert a wire (electrical or other) through the pipe
until it reaches the junction box. Use this thread as
a «needle» to guide the control tube through the
pipe
(pic 4)
•
Use the heat-retractable sheath to cover the
4 sleeves of electrical connections (pic 5)
•
Heat the sheath to retract it (pic 6)
•
Fit the front onto the part to be sealed
•
Assemble using the 3 M5 screws
cas commande électrique
pic 2
2
1
NEW JET VAG
ALVÉO’NOX
PRO LUXE
JUNIOR /JUNIOR PRO
