AUTOMATION COMPONENTS, INC Version : 4.0
2305 Pleasant View Road I0000685
Middleton, Wisconsin 53562
Page 2 of 4
Installation
Wireless sensors should be installed within 200 to 300 feet of the receiver. RR2552 signal repeaters can be
installed as to increase transmission distance between sensors and receivers.
CAUTION
Observe battery polarity when installing battery.
To select the proper sensor location,
first install and power the receiver
.
To activate the sensor insert the
battery observing the polarity.
The mesh networked Series 2000 system does not require any additional wireless
equipment to determine the proper location of the sensors.
While the sensor is attempting to connect to the receiver the Data-Link LED will blink rapidly 8–10 times every
10 seconds. Once a connection has been established the Data-Link LED will blink once to indicate the data
transmission has been received successfully. The Data-Link LED will continue to blink once for every data
transmission. The data transmission rate is programmed into the sensor (normally 1 minute intervals). To
manually initiate a data transmission press the push button switch located by the negative terminal of the battery.
Once the sensor location has been determined mount the sub-base on an inside wall approximately 4.5 feet from
the floor (or in the specified location) to allow exposure to the average zone temperature using two #8 screws,
Velcro™ or double sided tape.
Locate and record the sensor ID numbers located on a label inside the unit prior to mounting
Do not mount the sensors on an outside wall, on a wall containing water pipes or near air ducts. Avoid locations
that are exposed to discharge air from registers or radiation from lights, appliances, or the sun.
Attach the wall sensor to the sub-base by tightening the two locking screws at the bottom of the sub-base.
NOTE:
The locking screw must be installed for a secure installation. The screws are turned counter-clockwise
to secure the cover.
The sensor has a Low Battery LED that will start to blink continuously when the battery voltage is low. A low
battery signal is also sent to the receiver for remote indication that the battery should be replaced. If the battery
is not replaced in approximately 2 months the battery voltage will become so low that the Low Battery and Data-
Link LEDs will not blink. Replace the battery and the Data-Link LED will start blinking while the sensor is re-
establishing communications with the receiver.
PRECAUTIONS
S
ENSORS
,
REPEATERS AND RECEIVERS SHOULD
NOT
BE INSTALLED IN THE FOLLOWING AREAS
:
•
I
NSIDE METAL ENCLOSURE
/
PANEL
•
INSIDE OR IMMEDIATELY NEXT TO ELEVATOR SHAFT
/
ELEVATOR BANKS
•
IN FRONT OF OR IMMEDIATELY NEXT TO LARGE TREES OR LARGE BODY OF WATER
T
RANSMISSION DISTANCE AND PERFORMANCE WILL BE DRASTICALLY REDUCED
.
CAUTION
DO NOT USE THIS PRODUCT IN ANY SAFETY RELATED APPLICATIONS
WHERE HUMAN LIFE MAY BE AFFECTED
.
!
!
!