Automation Components, Inc.
2305 Pleasant View Road | Middleton, WI 53562
Phone:
1-888-967-5224 |
Website:
workaci.com
Page 1
Version: 8.0
I0000668
FIGURE 1:
ENCLOSURE DIMENSIONS
MOD9200BNT BACnet MSTP
NETWORK TRANSCEIVER
Installation & Operation Instructions
Phone:
1-888-967-5224
Website:
workaci.com
FRONT VIEW
SIDE PROFILE
FRONT
4.72"
(119.89mm)
3.50”
(88.90 mm)
8.26”
(209.80 mm)
7.63”
(184.50 mm)
2.37”
(60.10 mm)
8.78”
(223 mm)
Ø: 0.190” (4 PLCS.)
RJ45
RS232
ANTENNA
J1
TB2
J2
Init
Norm
A(+)
24 V
TB1
B(-)
A(+)
B(-)
SHLD
ACTIVE LED
DATA LINK
LED
Do not use this product in any safety related applications where human life may be affected.
GENERAL INFORMATION
ACI’s Wireless Series MOD9200BNT BACnet® network transceiver utilizes reliable Spread Spectrum Mesh
Network Radio technology. Together with other ACI wireless sensors and controls, the system can be used
to transmit remote sensor readings, status/alarm indications, control signals and outputs wirelessly. It is
compatible with any control panels or Automation Systems that utilize BACnet MSTP (Master Slave Token
Passing) communication protocol. Up to 50 separate physical wireless sensor transmitters and/or wireless
remote output (analog & digital) modules can be used with one MOD9200BNT Transceiver and up to 100
data points and 100 outputs can be monitored and controlled with one (1) MOD9200 Transceiver.
The maximum radio transmission distance is dependent on the building type. In a typical commercial
building with steel I-Beam construction, concrete floors with reinforcing rod, and metal stud walls, it can
be expected that transmissions will penetrate horizontally approximately 200-300 feet of floor, walls,
furniture and air.
RR2552 signal repeaters can be installed as needed to increase transmission distance between sensors and
receivers - see
FIGURE 2
(p. 2). Generally, a wireless system will cover at least three floors–one floor above,
and one floor below the receiver location. In some buildings with favorable transmission characteristics the
system may cover more floors - see
FIGURE 3
(p. 2). Wireless sensor transmitters should be installed within
200 to 300 feet of the MOD9200 transceiver.
PRECAUTIONS
• To maintain high performance, do not install sensors, repeaters, or receivers in the following areas:
- Inside metal enclosure / panel
- Inside or immediately next to elevator shaft or elevator banks
- In front of or immediately next to large trees or large body of water
