aci DSIM-GI, Руководство по установке

Страница: 14 / 19

DSIM-GI
Installation Guide Rev R
Page 14 of 20
10. Troubleshooting
1. DSIM does not lock on to the pilot:
a. Make sure the ADU pot has been turn to minimum level at the output of the
amplifier.
i. Most amplifiers are counter clockwise
ii. At least some Starline Amps. are clockwise
b. If the ADU pot configuration is un-known
i. install original ADU and place the ADU jumper in the AUTO position:
1. Turn the ADU pot clockwise and check the amp output level
2. Then turn the ADU counter clockwise and check the amp output level
3. Leave the ADU pot in the position with the lowest amp. output level
4. Remove the old ADU and start the DSIM setup again.
c. Occasionally the ADU PAD will need to be different:
i. If the ADU pot is set correctly try reducing the PAD value by 3dB.
2. If the controller 'mode' button does not change the mode:
a. Try to recycle the power.
b. Make sure the controller SW Rev is 204 or higher.