6
7
3. CONNECTING REMOTE TO RECEIVER
NOTE:
After 3 minutes of inactivity, the
remote control times out and deactivates its
communication hardware.
A. To activate the remote control
communication hardware and connect
to receiver, press Activate/Stop for
approximately 3 seconds.
NOTE:
The LED inside the Switch Control
activates when remote control is connected.
4. OPERATING INSTRUCTIONS
There are two methods for opening and closing the tarp with the remote. The method
depends on which operating mode is configured.
A. If inactive for 3 minutes, connect remote to
receiver as described in step 3.
B. Press < or > to choose the desired
channel.
C. Depending on operating mode, perform
one of the following:
Latching mode (switch setting 4):
Press
and release Open/Off
to roll tarp fully open.
Press and release Close/On to roll tarp
closed.
Momentary mode (switch setting 7):
Press
and hold Open/Off
to roll tarp fully open.
Press and hold Close/On to roll tarp closed.
D. (Optional) To halt the open or close
process during
Latching mode
, press the
toggle switch, tethered switch or one of the
remote control operation buttons (not channel
buttons).
NOTE:
If motor controller senses a fault 2 times consecutively in the same direction,
the tarp direction must be reversed before trying again.
