Carrying the Body-Pack receiver
• Easily clips on your belt, or if using a guitar, you can
attach it on the guitar sling vertically.
• Make sure to attach it securely flushed with your belt
to prevent it from falling off.
Changing the batteries
• Press the sides of the battery cover as pictured.
• While maintaining pressure simply pull outward
to open cover.
• Change batteries, close, and press down until cover
clicks securely.
Body-Pack receiver
1. Antenna
2. Operating indicator lights:
• green – power is ON
• yellow – power ON & Muted
• flashing red – IR Syncing / low batteries (auto turn off)
3. Power switch – hold on 2 sec for power on/off,
push once to Mute/ Unmute
4. Microphone input
5. Display window
6. IR Signal receiver
How to IR Sync
•
Manual Sync
– turn on the microphone,
select desired channel on the receiver, push
sync button once on receiver to syncing.
•
Auto IR Sync
1. Make sure microphone is on
2. Remove battery housing cover so the
IR sync receiver is visible.
3. Position the IR sync of the desired
microphone so is faces the IR sync
sensor at approximately 8” from the receiver.
4. Press the IR Sync button once. This will make the channel blink on the display panel.
5. When blinking stops, RF/AF indicator bar should be full.
6. Your microphone and receiver are now fully synced.
• SQ setting - SQ setting can adjust the receiver coverage area. When SQ setting at maximum, distant is
at its farthest. You can adjust the best receiver coverage depending on the environment.
3
