1-16
User’s Guide
5.
Press down the processor until the golden fingers completely fit
into the connector and the latches on the sides lock the processor
into place.
Figure 1-9
Locking the Processor
1.7
IDE Hard Disk Support
The board comes with an enhanced PCI IDE controller that supports
PIO mode 4 and Ultra DMA (Direct Memory Access) mode data
transfers. In addition, two PCI IDE interfaces are mounted on the riser
card to enable the system to support a maximum of four IDE hard
disks, or any other IDE devices. See Figure 1-2 for the location of the
IDE interfaces.
Connect the cables according to the IDE hard disk configuration in
Table 1-4. Follow the instructions in the housing installation manual
on how to install a hard disk in the system.
Table 1-4
IDE Hard Disk Configuration
IDE Connector
Master
Slave
IDE1 (CN9)
Hard disk 0
Hard disk 1
IDE2 (CN8)
Hard disk 2
Hard disk 3 /
IDE CD-ROM drive