English
26
Channel management
Open the Channel Management menu as described in the
OSD navigation
section. This
menu provides the following settings:
Auto scan
Auto scan allows you to scan for new or deleted channels. If you completed the setup
wizard the first time you turned on your TV, all available channels are listed.
To scan again, select the
Auto Scan
setting, and then your country from the Country List.
Use the directional keys to select
Start
and press the
OK
key.
Wait until the scan has finished; this will take several minutes.
Time zone
If there are multiple time zones in the country selection, set your local time zone here. In
countries with only one time zone this will be set automatically.
Digital manual scan
You can manually add a digital channel by searching in specific UHF channels. Use the left
or right directional keys to change the channel being scanned.
Analog manual scan
You can manually add an analog channel by adjusting the settings here. Use the up or
down directional kays to select a setting to change, use the left or right directional keys
to change the setting. You may set: the analog channel where the signal will be stored,
the encoding system, which direction to search through analog frequencies, fine tune to
a specific frequency and if this channel will be skipped in the channel list.
Use the left or right directional keys to change the channel being scanned.
Channel edit
You can edit the detected channels, to change how they are displayed in the channel list.
Use the up or down directional keys to select a channel, you may then use the coloured
keys to perform different actions:
*
Delete (red):
You can remove a channel from the
Channel List
. Press the red key once
to mark a channel for deletion, then press the red key again. Finally select
Yes
and
press the
OK
key to remove the channel. Press the
BACK
or
MENU
key to cancel.
*
Rename (green):
You can rename an analog channel (not digital channel as the
names are assigned by the broadcaster). Press the green key, then use the left or right
directional keys to select the character to change, then use the up or down directional
keys to change the letter. Names are limited to 5 characters. Press the green key to
confirm or
Menu
to cancel.
* Move (yellow):
Press the yellow key, then use the up or down directional keys to
move the channel up or down through the channel list. Press
OK
to confirm or
Menu
to cancel.
* Skip (blue):
Press the blue key to select channels you want to skip. These channels
will automatically be skipped when the
OK
key is used to select channels later on.
However, you can still manually select these channels.
