29
• On: Approx. 80%
Note
• When “Eco Mode” is set to “On”, the fan sound and power consumption are lower than
they are when “Off” is selected. (Projection brightness decreases.)
Light Source Hours
You can confirm the cumulative usage time.
Auto Power Off
• Disable: The Auto Power Off function will be disabled.
• 10 Min./20 Min./30 Min.: When no input signal is detected for more than selected
time, the projector will automatically enter Standby mode.
Note
• When the Auto Power Off function is set to other than “Disable”, 30 seconds before the
projector enters Standby mode, the message will appear on the screen
Quick Cooling
This function changes the cooling time.
• Off: The cooling time will be normal time.
• On: The cooling time is reduced.
Standby Settings
This function is setting power consumption reduction in standby mode.
LAN Control
You can be used Network function in Standby mode.
• Off: Network functions are switched off in Standby mode.
• On: Network functions are activated even if the projector is in Standby mode.
Network Settings
Allow you to configure the wired LAN settings. Refer to
Network Environment" on page 33
.
DHCP Client
Connect the LAN cable before turning the projector on. If not, the DHCP Client
function does not work.
• On: Obtains configuration parameters for TCP/IP network automatically.
• Off: Sets the TCP/IP manually.
When "
DHCP Client
" is set to "
On
", Select "
Save Settings
", then press
ENTER
.
IP Address
Factory default setting: 0. 0. 0. 0
Enter an IP address appropriate for the network.
Subnet Mask
Factory default setting: 0. 0. 0. 0
