Acer e-mill 3VK, Руководство по эксплуатации

Страница: 14 / 203

- 1 3 -
CAUTION
1) Check lubrication gauge for proper reading (only for 6VK) .
2) Check spindle, coolant motor (only for 6VK), powerfeeds (only for 6VK) and
other parts for abnormal noises.
3) Check the motor lubrication and sliding parts for evidence of proper lubrication.
4) Check safety covers and safety devices for proper operation (optional
accessories) .
2) Check belt tension. Replace any belt that has become str etched with a fres h
matching belt .
1-4-3. Warm-up
1) Warm up machine, espec ially the spindle and lubrication pump by running the m
for 10 to 20 minutes at about half or one -third the maximum speed in dicated on the
manual.
2) This self-warming -up program should activate each machine’s component t o
operate. At the same time please check their operations’ correctness.
3) Be particularly careful to warming u p the spindle, which can turn up to 45 00rpm.
If the machine is used for actual machining immediately after spindle start,
following a long idle p eriod, sliding parts such as bearings may be worn due to lack
of lubrication oil. Also, thermal expansion of the machine’s components can
jeopardize machining accuracy. To prevent this from happening, always warm the
machine up.
1-4-4. Preparations
WARNING
1)
Tooling should conform to the machine specification and dimensions’ types.
2)
Seriously worn -out tools can cause injuries. Replace all such tools with new
ones before intended operation.
3)
The work area should be adequately lighted to allow for safety checks.
4)
Tools and other items around the machine or equipment should be stored t o
ensure good footing and clear aisles.
5)
Tools or any items mu st not be place on the head housing, table, ram and other
similar places.
CAUTION
1) Tool lengths should be within specified tolera nces to prevent interference.
2) After installing a n ew tool, please make a trial cut .