40
En
gl
ish
<<Type II>>
Replacing the dust shield pack
Follow these steps:
Replacing the 3D dust filter
1
Turn the projector off. Wait for the Power LED to stop flashing then
unplug the power cord.
2
Allow the projector at least 30 mins to cool down.
3
Use a screwdriver to remove the screw from the 3D dust filter. (Illustration
#1)
4
Remove the 3D dust filter. (Illustration #2)
Replacing the Lens shield
1
Open the top cover from the lens shield. (Illustration #3)
2
Use a screwdriver to remove the screws from the lens shield. (Illustration
#4)
3
Remove the lens shield. (Illustration #5)
To install the 3D dust filter and lens shield, please reverse previous steps.
To reset 3D dust filter after installing.
Note: Considering the performance of 3D dust filter, it is not
recommended to clean the electrostatic filters. Please contact your
local dealer or serviced center to purchase and replace new
electrostatic filters inside 3D dust filter.
1
2
4
5
3
3D d
ust fi
lter
Le
ns shield
