Disassembly Procedures
1-19
3. Close the top assembly and lift the left side of LCD hinge until it is fully extended
(
).
Figure 1-25. USB Board Removal
4. Disconnect the 40-pin USB board FFC (B) from the mainboard and USB board
connectors (
).
5. Disconnect the G-sensor cable from the USB board connector (C) (
).
6. Disconnect the fingerprint cable from the USB board connector (D). Then unroute the
WLAN antennas cables from the cable guides (
).
7. Remove two (2) screws (E) securing the USB board in place (
Figure 1-26. USB Board Removal
B
C
D
E