Acer ATL 1840E, Руководство по эксплуатации

Страница: 46 / 76

Page 4-3
4.2.2 Cross slide
lf the gibs between slide and saddle become loose, it will affect the machining
You should regularly check and adjust them every six months according to the
following steps.
1)
Release the screw 1
2) Remove slide cover 2 as shown as figure shown, then the gibs can be seen.
3) Use flat head screw diver to release the adjust screw 3 about 1/2 circle
CCW
4) Tighten screw 4 about 1/2 circle CW.
5) Move the slide back and forth to a satisfied smoothness.
6) Re-assemble the cover 2
4.2.2 4.2.3
4.2.3 Saddle
lf the gibs between saddle and bed become loose, it will affect the accuracy of
saddle travel. Check and adjust them every six months according to the
following steps.
1)
Use flat head screw driver to loosen the adjust screw 1 & 2 as shown as Fig.
about 1/2 circle CCW.
2) Appropriately tighten adjust screw 3 & 4 as shown in figure about 1/2 circle
CW.
3) Move saddle left and right to a satisfied smoothness.
4.2.4 Aligning tailstock to spindle
If there is taper appearing on work piece while machining it by using tailstock.